No products in the cart.
LASHERS
lashers
Cable lashers make aerial fiber installations faster and safer by automating the process of securing fiber-optic cables to support strands. This automation provides consistent tension and alignment of cables, which protects against environmental damage and optimizes network performance. Our equipment experts can help you find the right fiber lasher for your project and budget.
Available Equipment
GMP J2
- Lash any single or multiple aerial cables up to 3 in. (76mm)
- Lashes to strand sizes from 1/4 in. to 7/16 in. (6 - 11mm). A factory modification will allow the lasher to accommodate 1/2 in. (12.7mm) strand if necessary
- Each of two recessed magazines will hold a 1200 ft. coil of .045 in. (365m of 1.1mm wire) lashing wire (or 450 ft. of .065 in.)
gmp super g
- This unit is designed to lash a large single or a combination of aerial cables to a supporting strand. It can be used for new installs or with existing cables in place
- Lashes cable from about 2-1/2 to 5-1/4 in. outside diameter or multiple cables up to 5-3/4 in. combined outside diameter
- Lashes on strand from 11/32 to 1/2 in. diameter with one or two spiral wrappings of .045, .061 or .065 in. diameter stainless steel wire
GMP Apollo
- Lashes any telcom cable/innerduct combination up to 4 in. (10cm) diameter
- Interference-free over-lashing with no modifications
- Positive slip-free gear drive (no belts) tested in excess of 1 million cycles
- Lashes to strand sizes 1/4 in. to 3/8 in. (6 – 10 mm) diameter
- Holds two coils of industry standard wire .045 in. x 1200 ft. (1.1mm x 365m) or .038 in. x 1600 ft. (1mm x 488m)
gmp c2
- Lashes single or bundled cables up to 1 7/8 in. (46mm)
- Lashes to strand sizes 1/4 in. to 3/8 in. (6-10mm)
- Simple wire routing yields either “normal” or “loose” wire tension
- Typical wire dimensions: 1200 ft. x .045 in. (365 m x 1.1mm) or 1600 ft. x .038 in. (487m x 1mm)
of 5
NEED TO RENT OR LEASE?
Fill out this form and we can help get your communites connected!
